   LAN Manager DOS workstations
                        
  This document applies to the EtherExpress(tm) 16, 16TP, 16C, FLASH,
  FLASH TP, FLASHC, MCA, and MCA/TP adapters.  It contains notes for 
  installing the NDIS driver in a LAN Manager* DOS workstation.  It 
  does not explain how to configure an EtherExpress adapter.  For 
  instructions about configuring the board, see the printed 
  installation guide.

 
  DOS WORKSTATIONS
  ----------------
  1. To use the EtherExpress card in a DOS workstation, follow the
     standard installation procedure (using the SETUP utility).  An
     EtherExpress adapter driver is included with LAN Manager 2.2, but 
     you should update that driver with the one on the EtherExpress
     adapter disk.
  
  2. Once you exit the SETUP utility, do NOT shut down the computer.
     Verify that the I/O address in the PROTOCOL.INI matches the I/O
     address of the board.  Refer to the "EDITING PROTOCOL.INI" section
     below for instructions on changing the I/O address.

  3. After exiting SETUP, reboot the computer as described in the
     manual.  If an error message is displayed, ensure that the board
     is installed properly and the I/O address in PROTOCOL.INI matches
     the board. 


  EDITING PROTOCOL.INI
  --------------------
  LAN Manager uses the PROTOCOL.INI file to ensure that the driver and
  the board are configured to work together.  Our driver requires only
  one parameter, and its purpose is to ensure that the driver and the
  board are configured to use the same I/O address.  The parameter's
  name is IOADDRESS.  If a board is using an I/O address other than
  300h, you must edit the PROTOCOL.INI file located in the directory
  \LANMAN.DOS to change configuration of the driver.

  1. Using a text editor, locate the EtherExpress section shown below:

     [EXP16_NIF]
        
     ; Intel EtherExpress(tm) 16 Ethernet Adapter.
        
     IOADDRESS=0x300
     DRIVERNAME=EXP16$

  2. Replace the I/O address with the address you selected when you
     ran SOFTSET for the EtherExpress 16 adapter or the System 
     Configuration utility for the EtherExpress MCA.
     
     Example using I/O address 340H:

     [EXP16_NIF]

     ; Intel EtherExpress(tm) 16 Ethernet Adapter.

     IOADDRESS=0x340
     DRIVERNAME=EXP16$

  3. Save the file and exit.

  The network driver now matches the configuration of the board and you
  should continue with rebooting the computer and loading the driver.


* Third-party trademarks are the property of their respective owners.
