| Does the system power up? |
0 |
| Did you get more than one beep? (One beep is all corrrect) |
See Beep Codes |
| Is the system totally dead? See Dead
System for hints |
See Troubleshoot |
| 85-K/N or 95A? Is JMP6
set? (up by op panel on both planars) |
See JMP6 |
| Does anything appear on the screen? |
0 |
| Screen in monochrome (not connected during boot, bad cable) |
0 |
| Blank screen (is pin in cable bent over?) |
0 |
| Does an error occur during POST? |
0 |
| Multiple Errors? |
See Multi-Error |
| Errors
163,
165 Config lost. (Low battery, exiting
setup improperly) |
0 |
| Errors 000095XX through
028331XX |
See General Errors |
| Errors 0037, 0096,
0104, 0112,
0206 |
See SCSI Errors |
| Improper cabling, termination, IDs,
adapter not fully seated |
See SCSI Layout |
| Errors I999XXX
(IML sytems only - 76/77/85/90/95/500/700/720) |
See IML
Errors |
| Does the system refuse to accept refdisk? |
0 |
| Do other floppies work? (If not, check type for known
problems) |
0 |
| Do you have the correct one? |
0 |
| Did you create it correctly? |
See Create
Refdisk |
| Do you have a Type 4 complex based system? (05 and up
needed) |
See BIOS
Releases |
| Adapter not recognized |
0 |
| Did you correctly add ADF to Refdisk? |
See Copy
ADF |
| Is the adapter fully seated? (can also cause odd run-time
errors) |
0 |
| No Bootable Device Found |
0 |
| Check SCSI Devices in setup |
See Set
SCSI Device |
| Check selectable drive startup |
See Startup
Sequence |
| Active Partition on boot drive? |
0 |
| Cannot Access CDROM |
0 |
| Properly terminated and proper ID? |
See SCSI Layout |
| Under DOS? |
See CD
Install |
| Does CD support parity? (required on IBM controllers) |
0 |
|
|
|
|