**************Readme.txt****************************************************
 
   Use WinZip to extract the file into a choosen directory. After that, the following two subdirectories should be found in the directory:
   \Bios	Including the new Bios and utility files
   \Driver     	The following subdirectories will be found in this directory:   
 		\NT40Drv	The Vision 1 AGP card driver for Windows NT 4.0;
  		\Win95Drv	The Vision 1 AGP card driver for Windows 95 OSR2.0&2.1 and Windows98;	
  		\Old95DRV     	The Vision 1 AGP card Driver(V3436) for windows 95 
		(4.00.950 )

  1.Firstly update the BIOS of your Vision-1 card before installing the new driver. Please refer to your Vision-1 manual or the Readme file concerning the updating instructions.   
  2.After the BIOS has been updated, you can install the display drivers for Windows 95, Windows 98 or Windows NT4.0.
  In Windows 95 (or 98, NT4.0), run setup.exe in \Driver directory, the operation system can be detected, then the corresponding display driver  
can be auto-installed, after that you can reboot your computer to complete the installation.
  If the driver can not be auto-installed, pls. change the display mode to standard VGA, then run the setup.exe file again.
  

  	