YAMAHA SOUND EDGE SW20 Version Up(ForWindows95) 

When installing SW20 with the install DISK version 1.00/1.01
There are some problems under Windows95 these are as follows

Problem1. Can not install DOS programs and Windows programs sequentially
Problem2. Your PC will hung up ,as OPL4TSR.SYS does not work under Windows95 
Problem3. OPLDLD.DRV  does not work  under Windows95 due to system memory resources 
Problem4. SampleEdit application does not work under Windows95

There are also some minor anomalies  in the Voyetra range of applications.

When using this Update disk, you are able to use SOUND EDGE under Windows 95.

Please update your SW20 software according to the following instructions.



1.  You have already installed  SW20 under Windows3.1 and you are planning to 
    install  Windows 95.
       (In this case you will have Problem 2,3&4)
    

Update Procedure
	Make sure that your SW20 works under Windows3.1.
	Before installing Windows 95, please run the update program under MS-DOS.
       (Please refer to the README.TXT regarding the instruction command)

	
2.  You have installed Windows95 in your PC and have previously installed SW20 under Windows3.1
(In this case you have Problem 2.3& 4  )
 Windows95 does not start, and the system appears to lock. This will be due to the old OPL4TSR.SYS.
	
Update Procedure
	1.Boot your PC from Windows95 Startup Disk(hopefully you have created a  Startup disk when you installed Windows95)
	2.Edit the current Config.sys with Editor software as follows, 
	  Remark the line ; DEVICE=c:\yamaha\opl4tsr.sys
	3.Update with the update program.


3.  You are going to install SW20 under Windows95 platform.
	(In this case you have Problem 1.2.3.&4)
	You need to update twice, under DOS & under   Windows95.

Update Procedure 

	Install & Update DOS Program
	1.Run Windows95
	2.Restart your PC in MS DOS(NOT DOS BOX) from Start Menu.
	3.Run Install.exe from the install DISK1.
	4.After DOS installation is completed ,the message"Do you want to Setup
	  the Windows environment (y/n)?" will be appeared . Please click "no" and quit the installation.
	5.Update your PC with the update program.

	Install & Update Windows program
  6.Remove the install Disk1,and restart Windows95.
	7.Insert the install Disk1.
	8.Install Windows program with  setup.exe in the install Disk1.
	9.Insert Disk2,3,&4 following to the message.
	10.You need to update windows program.
	11.Restart your PC in MS DOS(NOT DOS BOX)from Start Menu.
	12.Update your PC with the update disk.





