
WESTERN DIGITAL CORPORATION

WD1003V-SR1/SR2, WD1006V-SR1/SR2

Replaces WD1003-RAH/RA2 & WD1006-RAH/RA2 respectively

Data bus:                   16-bit, ISA
Size:                       Full-length, full-height card
Hard drive supported:       Two RLL ST506/412 drives
Floppy drives supported:    Two 360KB, 720KB, 1.2MB, or 1.44MB drives
Maximum heads/cyl.:         16 heads 2048 cylinders
Options                     Feature F301R has an optional ROM BIOS with
                            shadow Ram which enables controller to
                            interface with all types of ESDI drives
                            bypassing the systems ROM BIOS drive type
                            tables. Feature F300R does not include ROM
                            BIOS option and system ROM BIOS must contain
                            appropriate drive parameters.

[Image]

                           CONNECTIONS

                  Function                        Location

  34-pin data cable connector-floppy drive           CN1

  20-pin data cable connector-drive 1                CN3

  20-pin data cable connector-drive 0                CN4

  34-pin control cable connector-hard drive          CN5

  4-pin connector-drive active LED                   CN6

                        USER CONFIGURABLE SETTINGS

              Function                     Location           Setting

     Hard drives in latched mode        JP1/jumper 1           open

      Hard drives in non-latched         JP1/jumper 1          closed
      mode

     4 byte ECC                         JP1/jumper 2           open

      7 byte ECC                         JP1/jumper 2          closed

     Caching enabled                    JP1/jumper 3           open

      Caching disabled                   JP1/jumper 3          closed

     BIOS enabled                           JP2                open

      BIOS disabled                          JP2               closed

     Hard drive port address is             JP3                open
      1F0-1F7h

      Hard drive port address is             JP3               closed
      170-177h

     Floppy drive port address is           JP4                open
      3F0-3F7h

      Floppy drive port address is           JP4               closed
      370-377h

     Single speed floppy drives             JP5                open
      supported

      Dual speed floppy drives               JP5               closed
      supported

     Bracket ground option                  JP6                open
      disabled

      Bracket to board ground                JP6               closed
      connected

                       MISCELLANEOUS TECHNICAL NOTES

     Not all jumpers are installed. You must solder those that are not
    present. Do not combine single- and dual-speed floppy drives on the
   same controller card. This controller has a built-in low-level format
    program. To enter the progam run the DEBUG utility supplied with DOS
                    and at the prompt enter: G=CC00:5.

