
TEKRAM TECHNOLOGY CO., LTD.

DC-600CF

  Data bus:                  16-bit, ISA

  Size:                      Half-length, half-height card

  Hard drive supported:      Four IDE (AT) Interface drives

  Floppy drives supported:   Two 360KB, 720KB, 1.2MB, or 1.44MB drives

[Image]

                              CONNECTIONS

                    Function                           Location

  40-pin IDE (AT) Interface connector - IDE-0             CN1

  40-pin IDE (AT) Interface connector - IDE-1             CN2

  34-pin control cable connector - floppy drive           CN3

  4-pin connector - drive active LED                      JP1

  4-pin connector - cache error speaker                   JP2

                        USER CONFIGURABLE SETTINGS

              Function                    Location            Setting

     IDE-0 damping resistor                JDR0               open
      enabled

      IDE-0 damping resistor                JDR0              closed
      disabled

     IDE-1 damping resistor                JDR1               open
      enabled

      IDE-1 damping resistor                JDR1              closed
      disabled

  DRIVE ACTIVE LED ERROR CODES (IMMEDIATELY AFTER POWER-UP)

            Status                        Function

        One short flash            No cache DRAM installed

       Two short flashes                  CPU error

      Three short flashes                SRAM error

      Four short flashes                 Timer error

                       MISCELLANEOUS TECHNICAL NOTES

    Some versions of this board have two 512KB x 8 DRAM chips mounted in
   place of Bank 0. In such a case the board will work without additional
    memory. In all other cases a pair of 256KB, 1MB, or 4MB SIMM modules
          must be installed in Bank 0 for the board to function.

