
UNIDENTIFIED

GW-106V/GW-106V1

  Data bus:                  16-bit ISA

  Size:                      Three-quarter length, full-height card

  Hard drive supported:      Two ST506/412 drives

  Floppy drives supported:   360KB, 720KB, 1.2MB, 1.44MB

[Image]

                               CONNECTIONS

                    Function                             Location

  34-pin control cable connector - floppy drive             J1

  20-pin data cable connector - drive 1                     J3

  20-pin data cable connector - drive 0                     J4

  34-pin control cable connector - hard drive               J5

  4-pin connector - drive active LED                       JP1

                        USER CONFIGURABLE SETTINGS

                Function                    Location          Setting

     Latched hard drive mode enabled         JP2/A             open

      Non-latched hard rive mode              JP2/A            closed
      enabled

     Four byte ECC enabled                   JP2/B             open

      Reserved                                JP2/B            closed

     Caching enabled                         JP2/C             open

      Caching disabled                        JP2/C            closed

     Factory configured - do not             JP2/D             N/A
      alter

     Floppy drive interface primary           JP3              open
      address select

      Floppy drive interface alternate         JP3             closed
      address select

                   USER CONFIGURABLE SETTINGS(CONTINUED)

                Function                    Location          Setting

     Hard drive interface primary             JP4              open
      address select

      Hard drive interface alternate           JP4             closed
      address select

     Bracket ground disabled                  JP5              open

      Bracket ground enabled                   JP5             closed

     Floppy drive interface single            JP6              open
      speed enabled

      Floppy drive interface dual              JP6             closed
      speed enabled

  Note: The location of jumper JP5 is unspecified in manufacturer
  documentation.

