
LEADINGSPECT CORPORATION

PCI-SPECT

  Data bus:                  PCI-bus

  Size:                      Half-length, three quarter-height card

  Hard drive supported:      Four IDE (AT) interface drives

  Floppy drives supported:   None

[Image]

                               CONNECTIONS

                     Function                             Location

  40-pin IDE (AT) Interface connector - primary             JP2

  40-pin IDE (AT) Interface connector - secondary           JP3

  Drive active LED connector                                JP23

                        USER CONFIGURABLE SETTINGS

               Function                     Location          Setting

     Factory configured - do not             JP6               N/A
      alter

     Factory configured - do not             JP7               open
      alter

                               BIOS ADDRESS

            Address                     JP4                   JP5

              D800h             pins 2 & 3 closed     pins 2 & 3 closed

               C800h             pins 2 & 3 closed     pins 1 & 2 closed

               D000h             pins 1 & 2 closed     pins 2 & 3 closed

          Disabled (no BIOS      pins 1 & 2 closed     pins 1 & 2 closed
             installed)

                     PRIMARY IDE PORT INTERRUPT SELECT

       IRQ            JP16           JP17          JP18          JP19

   Interrupt A       closed          open          open          open

   Interrupt B        open          closed         open          open

   Interrupt C        open           open         closed         open

   Interrupt D        open           open          open         closed

  Note:The interrupt setting for the primary port must be the same as the
  setting for the secondary port.

                    SECONDARY IDE PORT INTERRUPT SELECT

       IRQ            JP15           JP20          JP21          JP22

   Interrupt A       closed          open          open          open

   Interrupt B        open          closed         open          open

   Interrupt C        open           open         closed         open

   Interrupt D        open           open          open         closed

  Note:The interrupt setting for the secondary port must be the same as
  the setting for the primary port.

