
SILICON STAR INTERNATIONAL, INC.

SC3210V VL-BUS SCSI

Data bus:                32-bit VESA
Size:                    Full-length, half-height card
Hard drive supported:    up to fourteen SCSI Interface drives
Floppy drives supported: Two 360KB, 720KB, 1.2MB, or 1.44MB drives

[Image]

                           CONNECTIONS

                  Function                        Location

  34-pin connector - Floppy drive interface          J1

  50-pin SCSI connector - internal                   J2

  50-pin SCSI connector - external                   J3

  4-pin connector - drive activity LED               JW1

                        USER CONFIGURABLE SETTINGS

               Function                    Location           Setting

     Floppy drive controller at 3FX          JP1              open
      address enabled

      Floppy drive controller                 JP1             closed
      disabled

     Hard drive controller address           JP2              open
      set at 17X

      Hard drive controller address           JP2             closed
      set at 1FX

     ROM address set at C800:0               JP3              open

      ROM address set at D800:0               JP3             closed

     VESA mode enabled                       JP4              open

      ISA mode enabled                        JP4             closed

     Factory configured - do not             JP5               N/A
      alter

     Factory configured - do not             JP6               N/A
      alter

     Factory configured - do not             JP7               N/A
      alter

     Floppy drive controller set at         JP13             closed
      DRQ2

      Floppy drive controller DRQ            JP13              open
      disabled

     Floppy drive controller                JP14             closed
      address set at IRQ6

      Floppy drive controller IRQ            JP14              open
      disabled

     Hard drive IRQ set at IRQ 15           JP15            pins 2 & 3
                                                              closed

      Hard drive IRQ set at IRQ 14           JP15            pins 1 & 2
                                                              closed

     Floppy drive controller set at         JP16             closed
      DACK2

      Floppy drive controller DACK           JP16              open
      disabled

                       MISCELLANEOUS TECHNICAL NOTE

  Note:When connecting additional SCSI devices, the user must make sure
  that proper termination is used on both ends of the SCSI bus. This
  controller is factory-configured to be the first SCSI device on the
  SCSI bus. Termination is supplied by resistor packs RP3, RP4, and RP5.

