
TMC RESEARCH CORPORATION

IFSPVL (VER. 2B)

  Data bus:                32-bit, VL-Bus

  Size:                    Three/quarter-length, full-height card

  Hard drive supported:    Two IDE (AT) interface drives

  Floppy drives            Two 360KB, 720KB, 1.2MB, or 1.44MB drives
  supported:

[Image]

                              CONNECTIONS

                    Function                           Location

  40-pin IDE(AT) interface connector                      J1

  34-pin control cable connector - floppy drive           J2

  16-pin game port - internal                             J3

  10-pin serial port (COM2/4) - internal                  J4

  9-pin serial port (COM1/3) - external                   J5

  25-pin parallel port (LPT1/2) - external                J6

  4-pin connector - Drive active LED                      JP1

                        USER CONFIGURABLE SETTINGS

               Function                    Location           Setting

     IDE(AT) controller enabled              JP2             closed

     IDE(AT) controller disabled             JP2              open

     CPU is 386DX                            JP3              open

     CPU is 486 (SX, DX, DX2,                JP3             closed
      Overdrive, 487SX, P24T)

     Floppy controller enabled               JP4             closed

     Floppy controller disabled              JP4              open

     Game port enabled                       JP5             closed

     Game port disabled                      JP5              open

     Parallel port (J6) is LPT1              RNG             pins 2-5
                                                              closed

     Parallel port (J6) is LPT2              RNG             pins 1-4
                                                              closed

     Parallel port disabled                  RNG             pins 4-7
                                                              closed

  Note: RNG is configured by installing a 4-pin resistor network over the
                            corresponding pins.

                        SERIAL PORTS CONFIGURATIONS

       Port 1 (J5)              Port 2 (J4)                 RNH

          COM1                     COM2               pins 1-4 closed

          COM1                   disabled             pins 2-5 closed

        disabled                   COM2               pins 3-6 closed

        disabled                 disabled             pins 4-7 closed

  Note: RNH is configured by installing a 4-pin resistor network over the
  corresponding pins.

