
TYAN COMPUTER CORPORATION

S1362 (REV. 1.0)

  Data bus:                  PCI local-bus

  Size:                      Half-length, half-height card

  Hard drive supported:      Four IDE (AT) interface drives

  Floppy drives supported:   None

[Image]

                          CONNECTIONS

                  Function                       Location

  40-pin IDE (AT) Interface connector               CN1

  4-pin connector - drive active LED                CN2

  40-pin IDE (AT) Interface connector               CN3

  10-pin connector - PCI Legacy IRQ Header         JP10

                        USER CONFIGURABLE SETTINGS

                Function                     Location         Setting

     Factory configured - do not alter         J1              N/A

     IRQ polarity meets PCI                    J2             closed
      specifications

      IRQ polarity does not meet PCI            J2              open
      specifications

     On-board IDE channel enabled              J3              open

      On-board IDE channel disabled             J3             closed

     Factory configured - do not alter         J90             N/A

                            PCI BUS IRQ SOURCE

          IRQ Source                    J4                    J5

         Primary IDE IRQ              open                 closed

         Secondary IDE IRQ            closed                 open

                                PCI BUS IRQ

         Setting               J6          J7          J8          J9

      IDE IRQ connected     closed       open        open        open
       to PCI bus IRQA

       IDE IRQ connected      open       closed       open        open
       to PCI bus IRQB

       IDE IRQ connected      open        open       closed       open
       to PCI bus IRQC

       IDE IRQ connected      open        open        open       closed
       to PCI bus IRQD

                       MISCELLANEOUS TECHNICAL NOTES

    JP10 is used to configure the card to comply with the PCI IDE Legacy
   convention. Pin 4 of JP10 connects to IRQ14 of the Legacy IRQ card to
  enable IRQ14. Pin 5 of JP10 connects to IRQ15 of the Legacy IRQ Card to
                              enabled IRQ15.

