
UNIDENTIFIED

HAF-M

  Data bus:                  16-bit ISA

  Size:                      Half-length, full-height card

  Hard drive supported:      Two IDE(AT) drives

  Floppy drives supported:   Two 360KB, 720KB, 1.2MB, or 1.44MB drives

[Image]

                        CONNECTIONS

                Function                      Location

  40-pin primary IDE(AT) connector               J1

  34-pin cable connector - floppy drive          J2

  9-pin serial port 1 - external                 P1

  25-pin parallel port - external                P2

  4-pin connector - drive active LED            JP1

  10-pin serial port 2 - internal               JP7

                        USER CONFIGURABLE SETTINGS

              Function                   Location            Setting

     Parallel port is LPT1                 JP2             pins 1 & 2
                                                              closed

      Parallel port is LPT2                 JP2             pins 2 & 3
                                                              closed

     Serial Port 2 is COM2                 JP3             pins 2 & 3
                                                              closed

      Serial Port 2 is COM4                 JP3             pins 1 & 2
                                                              closed

     Serial Port 1 is COM1                 JP4             pins 2 & 3
                                                              closed

      Serial Port 1 is COM3                 JP4             pins 1 & 2
                                                              closed

     IOCHRDY signal disabled               JP5                open

      IOCHRDY signal enabled                JP5               closed

     Floppy drive interface                JP6               closed
      enabled

      Floppy drive interface                JP6                open
      disabled

                   USER CONFIGURABLE SETTINGS CONTINUED

             Function                   Location             Setting

     Parallel port IRQ 7 select           JP8          pins 1 & 2 closed

      Parallel port IRQ 5 select           JP8          pins 2 & 3 closed

     Serial Port 1 IRQ4 select            JP9          pins 1 & 2 closed

      Serial Port 1 IRQ5 select            JP9          pins 2 & 3 closed

     Serial Port 2 IRQ3 select           JP10          pins 1 & 2 closed

      Serial Port 2 IRQ5 select           JP10          pins 2 & 3 closed

