
TEKRAM TECHNOLOGY CO., LTD.

DC-600CD

Data bus:                16-bit, ISA
Size:                    Half-length, half-height card
Hard drive supported:    Four IDE (AT) Interface drives
Floppy drives supported: Two 360KB, 720KB, 1.2MB, or 1.44MB drives

[Image]

                                CONNECTIONS

                     Function                             Location

  40-pin IDE (AT) Interface connector - IDE-0               CN1

  40-pin IDE (AT) Interface connector - IDE-1               CN2

  34-pin control cable connector - floppy drive             CN3

  40-pin IDE (AT) flat cable connector - CD-ROM             CN4
  drive

  4-pin connector - drive active LED                        JP1

  4-pin connector - cache error speaker                     JP2

  Factory configured - do not alter                         JP3

  DRIVE ACTIVE LED ERROR CODES (IMMEDIATELY AFTER POWER-UP)

            Status                        Function

        One short flash            No cache DRAM installed

       Two short flashes                  CPU error

      Three short flashes                SRAM error

      Four short flashes                 Timer error

                       MISCELLANEOUS TECHNICAL NOTES

    Some versions of this board have two 512KB x 8 DRAM chips mounted in
   place of Bank 0. In such a case the board will work without additional
    memory. In all other cases a pair of 256KB, 1MB, or 4MB SIMM modules
          must be installed in Bank 0 for the board to function.

