
KOUWELL ELECTRONICS CORPORATION

KW-801

Data Bus                32-bit PCI
Card Size               Half-height, half-length card
Hard Drives supported   Up to 7 SCSI-2 devices
Floppy drives supported None

[Image]

                                CONNECTIONS

       Function           Location          Function           Location

  50-pin SCSI                J1        2-pin connector -          J4
  connector - internal                 drive active LED

  50-pin SCSI                J2
  connector - external

                        USER CONFIGURABLE SETTINGS

                   Function                     Label        Position

      Active termination enabled                JP1          Closed

       Active termination disabled               JP1           Open

            Note: When BOTH external AND internal devices exist, disable
            on-board termination jumper JP1 and insert the resister array
            RP1-RP3. This setting is used if controller lies within the
            device chain. When only external devices OR only internal
            devices exist, enable JP1 and remove resister arry RP1-RP3.
            This setting is used when controller is at one end of device
            chain. (Location of resistors RP1-RP3 is unidentified.)

                          PCI INTERRUPT SELECTION

         Setting                    JP2                      JP3

            INTA            Pins 2 & 3 closed              Open

             INTB            Pins 1 & 2 closed              Open

             INTC                   Open              Pins 2 & 3 closed

             INTD                   Open              Pins 1 & 2 closed

