
KOUWELL ELECTRONICS CORPORATION

KW-602B

Data Bus                32-bit PCI
Card Size               Full-height, Half-length card
Hard Drives supported   Four IDE (AT) drives
Floppy drives supported None
Interface               IDE, ATAPI, ATA-2

[Image]

                                CONNECTIONS

         Function            Label            Function            Label

  40-pin connector -           J1       10-pin connector -         W1
  primary IDE                           paddle card

  2-pin connector -            J2       10-pin connector -        PCW1
  drive active LED                      controller

  40-pin connector -           J3
  secondary IDE

                        USER CONFIGURABLE SETTINGS

                  Function                      Label        Position

     Disk change enabled                        W2/1         Closed

      Disk change disabled                       W2/1          Open

     Factory configured - do not alter          W2/3          Open

                  PCI INTERRUPT SELECTION FOR PRIMARY IDE

        Setting            W3/1         W3/2         W3/3         W3/4

           INTA           Open         Open         Open        Closed

            INTB           Open         Open        Closed        Open

            INTC           Open        Closed        Open         Open

            INTD          Closed        Open         Open         Open

          Disabled         Open         Open         Open         Open

                 PCI INTERRUPT SELECTION FOR SECONDARY IDE

        Setting            W4/1         W4/2         W4/3         W4/4

            INTA           Open         Open         Open        Closed

           INTB           Open         Open        Closed        Open

            INTC           Open        Closed        Open         Open

            INTD          Closed        Open         Open         Open

          Disabled         Open         Open         Open         Open

                    LEGACY / NATIVE MODE CONFIGURATION

  Primary   Secondary     W3         W4        W5      W6    W7     W2/2
   IDE        IDE

  Legacy     Legacy    Enabled    Enabled     Open     2 &   2 &    Closed
   mode       mode                                     3      3

  Legacy     Native    Enabled    Disabled   Closed    2 &   Open   Open
   mode       mode                                     3

  Native     Legacy    Disabled   Enabled    Closed   Open   2 &    Open
   mode       mode                                            3

  Native     Native    Disabled   Disabled   Closed   Open   Open   Open
   mode       mode

            Note: Designated pins should be in the closed position.
            W6/pins 1 & 2 and W7/pins 1 & 2 are reserved.

            Note: Primary and secondary IDE drives are enabled by
            selecting a PCI interrupt or attaching the paddle card.
            Primary or secondary IDE drives are disabled by detaching the
            paddle card and disabling the PCI interrupt. To attach the
            paddle card, insert it into an ISA slot and connect PCW1 to
            W1. The paddle card is used to transfer IRQ14 and IRQ15
            signals to the PCI bus on older mainboards that do not have
            this capability.

                       MISCELLANEOUS TECHNICAL NOTES

    Your mainboard and BIOS determine operating modes. If your mainboard
     and BIOS support plug-and-play, the controller can operate in PCI
       native mode. If not, the controller operates in legacy mode.

