
LONGSHINE MICROSYSTEM, INC.

LCS-6624/B (UM-6624-B00)

Card Type               Hard drive controller card
Hard Drives supported   Two IDE (AT) drives
Floppy drives supported Two 360KB, 720KB, 1.2MB, or 1.44MB drives
Data Bus                16-bit ISA
Card Size               Half-length, half-height card

[Image]

                                CONNECTIONS

        Function          Location           Function           Location

  34-pin cable connector     J1       9-pin serial port 1 -        J5
  - floppy drive                      external

  40-pin primary IDE(AT)     J2       25-pin parallel port -       J6
  connector                           external

  16-pin game port           J3       2-pin connector -           JP1
                                      drive active LED

  10-pin serial port 2 -     J4
  internal

                        USER CONFIGURABLE SETTINGS

                   Function                      Label        Position

     Hardware configuration setting              JP3        Pins 2 & 3
                                                               closed

      Software configuration setting              JP3        Pins 1 & 2
                                                               closed

     Factory configured - do not alter           JP5          Closed

     Floppy drive interface enabled              JP6          Closed

      Floppy drive interface disabled             JP6           Open

                      PARALLEL PORT ADDRESS SELECTION

           Setting                    JP10                   JP11

           LPT1 (378h)         Pins 2 & 3 closed      Pins 1 & 2 closed

          LPT2 (278h)         Pins 1 & 2 closed      Pins 1 & 2 closed

           LPT3 (3BCh)         Pins 1 & 2 closed      Pins 2 & 3 closed

            Disabled           Pins 2 & 3 closed      Pins 2 & 3 closed

                    SERIAL PORT 1 & 2 ADDRESS SELECTION

        Setting               JP7              JP8              JP9

     Serial 1 COM1 /       Pins 1 & 2       Pins 1 & 2       Pins 1 & 2
     serial 2 COM2           closed           closed           closed

     Serial 1 COM1 /       Pins 1 & 2       Pins 2 & 3       Pins 1 & 2
   serial 2 disabled         closed           closed           closed

     Serial 1 COM2 /       Pins 1 & 2       Pins 1 & 2       Pins 2 & 3
     serial 2 COM1           closed           closed           closed

   Serial 1 disabled /     Pins 2 & 3       Pins 1 & 2       Pins 2 & 3
     serial 2 COM1           closed           closed           closed

   Serial 1 disabled /     Pins 2 & 3       Pins 1 & 2       Pins 1 & 2
     serial 2 COM2           closed           closed           closed

     Serial 1 COM2 /       Pins 1 & 2       Pins 2 & 3       Pins 2 & 3
   serial 2 disabled         closed           closed           closed

   Serial 1 disabled /     Pins 2 & 3       Pins 2 & 3          N/A
   serial 2 disabled         closed           closed

       IDE INTERFACE ENABLE

  Setting       JP2        JP4

   Enable     Closed      Closed

  Disabled     Open        Open

