
ACQUTEK CORPORATION

PM-8002

Card Type              Virtual memory card
Chip Set               None
Maximum Onboard Memory 1MB EPROM
I/O Options            Watch dog timer connector
Data Bus               8-bit ISA

[Image]

                                CONNECTIONS

                     Function                               Label

  Watch-dog timer reset connector                            JP2

  Note: Watch-dog timer reset connector can be connected to mother board
  or CPU cards reset connector.

                        USER CONFIGURABLE SETTINGS

                 Function                    Label         Position

     Factory configured - do not alter       JP1        Unidentified

     Factory configured - do not alter       JP3      Pins 1 & 2 closed

                              DIAGNOSTIC LED

                     Function                               Label

  Watch dog timer status indicator                           L1

  Note: When watch-dog timer is enabled, LED will start to blink. The
  user must refresh the watch-dog time every 6 to 42 seconds or the LED
  will stop blinking and the watch-dog timer will reset the system.

     BIOS ADDRESS SELECTION

  Address    SW1/3      SW1/4

  CC000h      Off        Off

  D0000h       On        Off

  D4000h      Off        On

  D8000h       On        On

   BASE I/O ADDRESS SELECTION

  Setting    SW1/1      SW1/2

   218h       Off        Off

   298h        On        Off

   318h       Off        On

   398h        On        On

                       MISCELLANEOUS TECHNICAL NOTES

  The following 2 chip memory kits are available: MK-2E10 (256KB),
  MK-2E20 (512 KB), MK-2E40 (1MB)

