
COMTROL CORPORATION

ROCKETPORT 485

Card Type        Serial card
Chip Set         Unidentified
I/O options      8 Serial ports via 25-pin connector
Data Bus         16-bit ISA

[Image]

                                CONNECTIONS

         Function           Label            Function             Label

  8 serial ports vis         CN1       DC power connector          CN2
  25-pin connector

  Note: Connector is used to supply voltage to peripheral devices through
  ports 3-8. Power may be supplied through 25-pin or 9-pin serial
  connectors.

                           PORT 1 MODE SELECTION

    Mode        JP1/A     JP1/B     JP1/C     JP1/D     JP1/E      JP1/F

   RS-232       Pins 2    Pins 2    Pins 2    Pins 2    Pins 2     Pins 2
                 & 3       & 3       & 3       & 3       & 3        & 3

   RS-485       Pins 1    Pins 1    Pins 1    Pins 1    Pins 1     Pins 1
                 & 2       & 2       & 2       & 2       & 2        & 2

  Note: Pins designated are in the closed position. RJ-485 ports must
  also be software configured.

                           PORT 2 MODE SELECTION

    Mode        JP2/A     JP2/B     JP2/C     JP2/D     JP2/E      JP2/F

   RS-232       Pins 2    Pins 2    Pins 2    Pins 2    Pins 2     Pins 2
                 & 3       & 3       & 3       & 3       & 3        & 3

   RS-485       Pins 1    Pins 1    Pins 1    Pins 1    Pins 1     Pins 1
                 & 2       & 2       & 2       & 2       & 2        & 2

  Note: Pins designated are in the closed position. RJ-485 ports must
  also be software configured.

                               PORT 3 POWER

                 Setting                                JP3

                 Disabled                             Open

                     +5V                              Closed

  Note: Port is equipped with a fuse to break the circuit if the device
  draws more than .5 amp.

                               PORT 4 POWER

                 Setting                                JP4

                 Disabled                             Open

                     +5V                              Closed

  Note: Port is equipped with a fuse to break the circuit if the device
  draws more than .5 amp.

                               PORT 5 POWER

                 Setting                                JP5

                 Disabled                             Open

                     +5V                              Closed

  Note: Port is equipped with a fuse to break the circuit if the device
  draws more than .5 amp.

                               PORT 6 POWER

                 Setting                                JP6

                 Disabled                             Open

                     +5V                              Closed

  Note: Port is equipped with a fuse to break the circuit if the device
  draws more than .5 amp.

                               PORT 7 POWER

                 Setting                                JP7

                 Disabled                             Open

                     +5V                              Closed

  Note: Port is equipped with a fuse to break the circuit if the device
  draws more than .5 amp.

                               PORT 8 POWER

                 Setting                                JP8

                 Disabled                             Open

                     +5V                              Closed

  Note: Port is equipped with a fuse to break the circuit if the device
  draws more than .5 amp.

                         BOARD 1 ADDRESS SELECTION

  Setting   SW1/1   SW1/2   SW1/3   SW1/4   SW1/5   SW1/6   SW1/7   SW1/8

      100h   Off     On      Off     On      On      On      On      On

      140h   On      Off     Off     On      On      On      On      On

     180h   Off     Off     Off     On      On      On      On      On

      200h   Off     On      On      Off     On      On      On      On

      240h   On      Off     On      Off     On      On      On      On

      280h   Off     Off     On      Off     On      On      On      On

      300h   Off     On      Off     Off     On      On      On      On

      340h   On      Off     Off     Off     On      On      On      On

      380h   Off     Off     Off     Off     On      On      On      On

  Note: Board one switch settings determines other controller settings. A
  different address should be selected for each board.

                         BOARD 2 ADDRESS SELECTION

  Setting   SW1/1   SW1/2   SW1/3   SW1/4   SW1/5   SW1/6   SW1/7   SW1/8

   100h     Off      On     Off      On      On      On      On      On

   140h      On     Off     Off      On      On      On      On      On

   180h     Off     Off     Off      On      On      On      On      On

   200h     Off      On      On     Off      On      On      On      On

   240h      On     Off      On     Off      On      On      On      On

   280h     Off     Off      On     Off      On      On      On      On

   300h     Off      On     Off     Off      On      On      On      On

   340h      On     Off     Off     Off      On      On      On      On

   380h     Off     Off     Off     Off      On      On      On      On

                         BOARD 3 ADDRESS SELECTION

  Setting   SW1/1   SW1/2   SW1/3   SW1/4   SW1/5   SW1/6   SW1/7   SW1/8

   100h     Off      On     Off      On      On      On      On      On

   140h      On     Off     Off      On      On      On      On      On

   180h     Off     Off     Off      On      On      On      On      On

   200h     Off      On      On     Off      On      On      On      On

   240h      On     Off      On     Off      On      On      On      On

   280h     Off     Off      On     Off      On      On      On      On

   300h     Off      On     Off     Off      On      On      On      On

   340h      On     Off     Off     Off      On      On      On      On

   380h     Off     Off     Off     Off      On      On      On      On

                         BOARD 4 ADDRESS SELECTION

  Setting   SW1/1   SW1/2   SW1/3   SW1/4   SW1/5   SW1/6   SW1/7   SW1/8

   100h     Off      On     Off      On      On      On      On      On

   140h      On     Off     Off      On      On      On      On      On

   180h     Off     Off     Off      On      On      On      On      On

   200h     Off      On      On     Off      On      On      On      On

   240h      On     Off      On     Off      On      On      On      On

   280h     Off     Off      On     Off      On      On      On      On

   300h     Off      On     Off     Off      On      On      On      On

   340h      On     Off     Off     Off      On      On      On      On

   380h     Off     Off     Off     Off      On      On      On      On

