
PROTEON, INC.

PRONET-10 P1300/V, P1303

NIC Type      Token-Ring
Transfer Rate 4Mbps
Data Bus      8-bit ISA
Topology      Ring
Wiring Type   Shielded twisted pair
Boot ROM      Available

[Image]

                          NODE ADDRESS SELECTION

  Node   SW2/1    SW2/2   SW2/3   SW2/4    SW2/5   SW2/6    SW2/7   SW2/8

   0       -       -        -       -       -        -       -        -

   1      Off      On      On      On       On      On       On      On

   2      On      Off      On      On       On      On       On      On

   3      Off     Off      On      On       On      On       On      On

   4      On       On      Off     On       On      On       On      On

  251     Off     Off      On      Off     Off      Off     Off      Off

  252     On       On      Off     Off     Off      Off     Off      Off

  253     Off      On      Off     Off     Off      Off     Off      Off

  254     On      Off      Off     Off     Off      Off     Off      Off

  255     Off     Off      Off     Off     Off      Off     Off      Off

  Notes: Node address 0 is used for messaging between nodes and must not
  be used.

  A total of 255 node address settings are available. The switches are a
  binary representation of the decimal node addresses. Switch 1 is the
  Least Significant Bit and switch 8 is the Most Significant Bit. The
  switches have the following decimal values: switch 1=1, 2=2, 3=4, 4=8,
  5=16, 6=32, 7=64, 8=128. Turn off the switches and add the values of
  the off switches to obtain the correct node address. (On=0, off=1)

  INTERRUPT REQUEST SELECTION

      IRQ             JP1

       2            Option 2

       3            Option 1

       4            Option 3

                          BOOT ROM CONFIGURATION

       Setting           SW1/1        SW1/2         SW1/3        SW1/4

        Disabled         Off          Off           Off          Off

         Enabled          On           Off           Off           On

       Note: The boot ROM socket has 28 pins. The boot ROM has only 24.
       Insert the ROM so that the 4 pins nearest the pin-1 socket notch
       are empty.

                I/O ADDRESS SELECTION

  Address    SW1/5      SW1/6      SW1/7      SW1/8

   300h        On         On        On         On

   308H        On         On        On         Off

   310h        On         On        Off        On

   340h       Off         On        On         On

  FACTORY CONFIGURED SETTINGS

     Jumper         Setting

      JP2             Open

      JP6

                       MISCELLANEOUS TECHNICAL NOTES

  Note: on cards prior to Rev.C, SW1 is located at the bottom left of the
  board.

