
PURE DATA LTD.

PD1516PLUS-H (HIGH IMPEDANCE)

NIC Type      ARCnet
Transfer Rate 2.5Mbps
Data Bus      16-bit ISA
Topology      Linear Bus
Wiring Type   RG-62A/U 93ohm coaxial
Boot ROM      Available

[Image]

                        CONFIGURATION MEMORY CLEAR

                  Clear                                 JP1

              Normal operation                         Open

       Clear all addresses and settings                Closed
                 from memory

  Note: When JP1 is closed all card addresses and settings are cleared
  from memory.

                              CARDS INSTALLED

  Card number        JP2A          JP2B           JP2C           JP2D

       1            Closed         Open           Open           Open

       2             Open         Closed          Open           Open

       3             Open          Open          Closed          Open

       4             Open          Open           Open          Closed

       Note:If there is only one NIC installed in a system, set this
       option to the "1" position. If this NIC is the second NIC to be
       installed in a system, set this option to the "2" position and so
       on.

                            COMPATIBILITY MODE

                 Condition                               JP3

         Compatibility mode disabled                    Open

           Compatibility mode enabled                   Closed

       Note: Compatibility mode should be enabled only when the NIC is
       installed in a system using a Suntac 286 chipset.

                            TERMINATION JUMPER

                Condition                                JP4

          Termination mode disabled                    Open

           Termination mode enabled                    Closed

  Note: Termination mode should be enabled when the NIC is installed on
  the end of a coaxial bus, therefore no external terminator is needed.

                             DIAGNOSTIC LED(S)

     LED         Color         Status                 Condition

    LED1          Red         Blinking            I/O bus activity

    LED1          Red            Off             No I/O bus activity

    LED2         Green           On          Data is being transmitted or
                                                      received

    LED2         Green        Blinking      No network activity detected,
                                                  or bad connection

