
DANPEX CORPORATION

EN-2010BT

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      16-bit ISA
Topology      Star
Wiring Type   Shielded/Unshielded twisted pair

              AUI transceiver via DB-15 port
Boot ROM      Available

[Image]

                             DIAGNOSTIC LED(S)

     LED         Color         Status                Condition

    LED1         Green           On            Data is being received

    LED1         Green           Off         Data is not being received

    LED2          Red            On             Card is transmitting
                                                constantly (Jabber)

    LED2          Red            Off              Normal operation

    LED3         Green           On          Data is being transmitted

    LED3         Green           Off       Data is not being transmitted

    LED4         Yellow          On        Collision detected on network

    LED4         Yellow          Off          No collisions detected on
                                                      network

                              SEGMENT LENGTH

                 Length                                JP1

              Less than 100m                   Pins 2 & 3 closed

             Greater than 100m                  Pins 1 & 2 closed

  Note:Segment length is the total length of cable between the card and
  the multiport repeater (MPR).

                      SIGNAL QUALITY ERROR (SQE) TEST

                Setting                                 JP2

                 Disabled                       Pins 2 & 3 closed

                   Enabled                       Pins 1 & 2 closed

  Note:The Signal Quality Error (SQE) test is a test of the collision
  circuitry and path.

                            LINK INTEGRITY TEST

                Setting                                 JP3

                  Enabled                       Pins 1 & 2 closed

                  Disabled                       Pins 2 & 3 closed

  Note:The link integrity test is valid only when the cable type is
  shielded/unshielded twisted pair.

                                CABLE TYPE

                     Type                               W1 - W6

        Shielded/Unshielded twisted pair          Pins 1 & 2 closed

          AUI transceiver via DB-15 port           Pins 2 & 3 closed

                            COMPATIBILITY MODE

                 Setting                                W7

                  Disabled                            Open

                   Enabled                            Closed

  Note:If the system in which the card is to be installed uses a Chips &
  Technology chipset, or if the system does not boot properly with the
  card installed, compatibility mode should be enabled (W7 closed).

                 I/O BASE ADDRESS & BOOT ROM BASE ADDRESS

    I/O Address       Boot ROM Address         W8                W9

         300h             C8000h            Closed            Closed

          320h             CC000h             Open             Closed

          340h             D0000h            Closed             Open

          360h              N/A               Open              Open

  Note:I/O address 360h cannot be used when a boot ROM is installed.

                                 BOOT ROM

                 Setting                                W10

                 Disabled                             Open

                   Enabled                            Closed

                             INTERRUPT REQUEST

      IRQ            W11            W12           W13            W14

         2/9        Closed         Open           Open           Open

         3          Open         Closed          Open           Open

          4          Open          Open          Closed          Open

          5          Open          Open           Open          Closed

