
KODIAK TECHNOLOGY, INC.

KODIAK~8 10BT

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      8-bit ISA
Topology      Linear bus
Wiring Type   Unshielded twisted pair
Boot ROM      Available

[Image]

                               CABLE LENGTH

                 Legth                                  JP1

               < 100 meters                           Open

                > 100 meters                          Closed

  Note:The hub must also support cable lengths greater than 100 meters if
  the >100m option is used.

                                 BOOT ROM

                 Setting                               JP2A

                  Disabled                            Open

                   Enabled                            Closed

       Note:In earlier versions of this card there is no socket for a
       boot ROM. If you have one of these earlier socketless versions and
       you purchased it less than five years ago, you may return it to
       the manufacturer for an updated version. You can also solder in a
       socket for a boot ROM but you will void the warranty.

        BOOT ROM ADDRESS

  Address     JP2B      JP2C

  C8000h     Closed    Closed

  CC000h     Closed     Open

  D8000h      Open     Closed

  DC000h      Open      Open

                             I/O BASE ADDRESS

          Address                   JP2D                    JP2E

             200h                  Closed                  Closed

             210h                  Closed                   Open

            300h                   Open                   Closed

             310h                   Open                    Open

                             INTERRUPT REQUEST

           IRQ                 JP2F            JP2G             JP2H

              2               Closed           Open             Open

             3                Open           Closed            Open

              5                Open            Open            Closed

        Programmed I/O         Open            Open             Open

                      TRANSMIT/RECEIVE WIRE POLARITY

                Setting                         SW1 (SW1/1 & SW1/2)

                  Normal                               On

                  Reversed                              Off

  Note:If the transmit/receive wires are reversed, they can be corrected
  for by setting this option to reversed. On some earlier versions of
  this card there are two switches, SW1/1 & SW1/2. On these older cards
  each switch should be set the same.

  FACTORY CONFIGURED SETTINGS

     Jumper         Setting

      JP4            Unused

                             DIAGNOSTIC LED(S)

         LED1                 Hub LED                  Condition

          On                    On            Network connection is good

         Off                    Off           Tx/Rx polarity crossover at
                                                        adapter

  Note:The Hub LED is located on the Hub not the NIC.

  If a crossover condition exists this can be corrected for by using
  switch SW1.

