
DANPEX CORPORATION

EN/2

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      16-bit MCA
Topology      Linear bus
Wiring Type   RG-58A/U 50ohm coaxial

              AUI transceiver via DB-15 port
Boot ROM      Available

[Image]

                                CABLE TYPE

                   Type                              JP2B - JP2I

           RG-58A/U 50ohm coaxial                Pins 1 & 2 closed

        AUI transceiver via DB-15 port            Pins 2 & 3 closed

                            ONBOARD TERMINATOR

                Setting                                 JP3

                 Disabled                       Pins 1 & 2 closed

                   Enabled                       Pins 2 & 3 closed

  Note:If the card is on either end of a linear bus network segment, the
  onboard terminator may be used instead of an external terminator

       FACTORY CONFIGURED SETTINGS

       Jumper              Setting

         JP1                Unused

        JP2A          Pins 2 & 3 closed

                         DIAGNOSTIC LED(S)

       LED             Status                  Condition

       LED1              On            Data is being transmitted

       LED1              Off          Data is not being transmitted

       LED2              On           Collision detected on network

       LED2              Off                Normal operation

       LED3              On              Data is being received

       LED3              Off           Data is not being received

