
ACTINET SYSTEMS, INC.

ARCTALK LC

NIC Type      ARCnet
Transfer Rate 2.5Mbps
Data Bus      32-bit LC 020 Processor Direct Slot
Topology      Star
Wiring Type   RG62/U 93ohm coaxial or

              Unshielded twisted pair (RJ-11)
Boot ROM      Not available

[Image]

           SEGMENT LENGTH AND RESPONSE/RECONFIGURATION TIMEOUTS

    Maximum       Response       Reconfig.         ET1           ET2
    Length         Time            Time

  22,000 feet      74.7s          840ms        Pins 1 & 2    Pins 1 & 2
                                                 closed         closed

  96,000 feet     283.4s         1680ms        Pins 2 & 3    Pins 1 & 2
                                                 closed         closed

    195,000       561.8s         1680ms        Pins 1 & 2    Pins 2 & 3
     feet                                        closed         closed

    393,000       1118.6s        1680ms        Pins 2 & 3    Pins 2 & 3
     feet                                        closed         closed

  Note:All NICs on the network must have this option set the same.

                             DIAGNOSTIC LED(S)

    LED        Color        Status                  Condition

   LED1        Green          On                Normal operation

   LED1        Green       Blinking      There is a break in the network
                                         (not necessarily at this card)

   LED1        Green         Off                 Fault detected

   LED2         Red       On < 1 sec    Card is checking or selecting its
                                                 node address/ID

   LED2         Red          Off                Normal operation

  Note: LED2 will light momentarily when the computer is first turned on,
  it should then remain off. If a fault is detected (LED1 off), the fault
  could be any one or a combination of the following: Card is not
  attached to an active network, the card is not selected in the control
  panel, AppleTalk is not enabled in the Chooser, the hybrid transceiver
  on the card is defective, there are no active stations on the network,
  the Mac's -12VDC power supply is malfunctioning, the hub is defective,
  or there is a break in the network cable.

