
LANCAST

ENC-4104

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      16-bit ISA
Topology      Linear bus
Wiring Type   Unshielded twisted pair

              AUI transceiver via DB-15 port
Boot ROM      Available

[Image]

                                CABLE TYPE

                   Type                              JP1A - JP1G

           Unshielded twisted pair               Pins 1 & 2 closed

         AUI transceiver via DB-15 port           Pins 2 & 3 closed

                            COMPATIBILITY MODE

                 Setting                                JP2

                  Disabled                      Pins 1 & 2 closed

                   Enabled                       Pins 2 & 3 closed

  Note: On some systems the data bus timing is not truly IBM PC/AT
  compatible. If the card is not initializing, enabling compatibility
  mode may allow the card to operate properly.

                             INTERRUPT REQUEST

           IRQ                     SW1/1                    SW1/2

              2                      On                      On

             3                      On                      Off

              4                     Off                      On

              5                     Off                      Off

                             I/O BASE ADDRESS

          Address                    SW1/3                  SW1/4

          300 - 31Fh                  On                     On

           320 - 33Fh                  On                    Off

           340 - 35Fh                 Off                     On

           360 - 37Fh                 Off                    Off

                             BOOT ROM ADDRESS

      Base Address            SW1/5            SW1/6            SW1/7

       C0000 - C3FFFh          On               On               On

       C4000 - C7FFFh          Off              On               On

      C8000 - CBFFFh          On               Off              On

       CC000 - CFFFFh          Off              Off              On

       D0000 - D3FFFh          On               On               Off

       D4000 - D7FFFh          Off              On               Off

       D8000 - DBFFFh          On               Off              Off

       DC000 - DFFFFh          Off              Off              Off

                                 BOOT ROM

                 Setting                               SW1/8

                  Disabled                             Open

                   Enabled                             Closed

                             DIAGNOSTIC LED(S)

     LED           Status                       Condition

     LED1         Blinking         Card is transmitting for an extended
                                              time (Jabber)

     LED1            On                      Normal operation

     LED2         Blinking            Collision detected on network

     LED2            On                      Normal operation

     LED3         Blinking                Data is being received

     LED3            On          Data is not being received /Twisted pair
                                         network connection good

     LED3            Off          Twisted pair network connection broken

     LED4         Blinking              Data is being transmitted

     LED4            Off              Data is not being transmitted

  Note: The function of LED3 is dependent on the cable type selected.

  LED3 will indicate twisted pair network connection only when the cable
  type is twisted pair.

