
STANDARD MICROSYSTEMS CORPORATION

WD8003EB

NIC Type      Ethernet
Transfer Rate 10Mbps
Data Bus      8-bit ISA
Topology      Linear bus
Wiring Type   RG-58A/U 50ohm coaxial

              AUI transceiver via DB-15 port
Boot ROM      Available

[Image]

                              NIC CMOS RESET

                 Setting                                 W1

               Normal operation                        Open

                     Reset                             Closed

  Note: To reset the NIC's settings you must: close W1, turn on the
  computer, run the setup utility included with the card, turn off the
  computer, open W1, and then reapply power to the card.

  When the card is reset the I/O base address will be set to 280h.

                                CABLE TYPE

                   Type                               W3A & W3B

            RG-58A/U 50ohm coaxial               Pins 2 & 3 closed

         AUI transceiver via DB-15 port           Pins 1 & 2 closed

                               BOOT ROM SIZE

           Size                      W9A                     W9B

            16KB             Pins 1 & 2 closed       Pins 1 & 2 closed

             32KB             Pins 2 & 3 closed       Pins 1 & 2 closed

             64KB             Pins 2 & 3 closed       Pins 2 & 3 closed

                         MISCELLANEOUS NOTES

  IRQ and Base I/O are set using the utility included with the card.

