
ALLEN-BRADLEY

VISTALAN/PC MODELS 7310, 7320 (REV. B)

NIC Type              VistaLAN (proprietary)
Network Transfer Rate Unidentified
Data Bus              8-bit ISA
Topology              Linear Bus
Wire Type             RG-6A/U 75ohm coaxial
Boot ROM              Available

[Image]

                             CONNECTIONS

             Function                            Label

  RG-6A/U 75ohm coaxial connector                 CN1

                               NODE ADDRESS

  Setting   SW1/1   SW1/2   SW1/3   SW1/4   SW1/5   SW1/6   SW1/7   SW1/8

    1       Off      On      On      On      On      On      On      On

    2        On     Off      On      On      On      On      On      On

    3       Off     Off      On      On      On      On      On      On

    4        On      On     Off      On      On      On      On      On

    5       Off      On     Off      On      On      On      On      On

   251      Off     Off      On     Off     Off     Off     Off      Off

   252       On      On     Off     Off     Off     Off     Off      Off

   253      Off      On     Off     Off     Off     Off     Off      Off

   254       On     Off     Off     Off     Off     Off     Off      Off

   255      Off     Off     Off     Off     Off     Off     Off      Off

            Note: A total of 255 node address settings are available. The
            switches are a binary representation of the decimal node
            addresses. SW1/8 is the Most Significant Bit and switch SW1/1
            is the Least Significant Bit. The switches have the following
            decimal values: SW1/8=128, SW1/7=64, SW1/6=32, SW1/5=16,
            SW1/4=8, SW1/3=4, SW1/2=2, SW1/1=1. Turn off the switches and
            add the values of the switches that are off to obtain the
            correct node ID. (Off=1, On=0)

            Node address 0 is reserved and should not be used.

                                 INTERRUPT

               Setting                              E1, E3

                IRQ2                               E1 closed

                IRQ3                       E1 pin 2, E3 pin 1 closed

                IRQ4                       E1 pin 2, E3 pin 2 closed

                IRQ5                       E1 pin 2, E3 pin 3 closed

            Note:The settings for IRQ3, IRQ4, and IRQ5 may not be set
            without a wire-wrapping tool.

