
ALLEN-BRADLEY

VISTALAN/PC MODELS 7310, 7320 (REV. A)

NIC Type              VistaLAN (proprietary)
Network Transfer Rate Unidentified
Data Bus              8-bit ISA
Topology              Linear Bus
Wire Type             RG-6A/U 75ohm coaxial
Boot ROM              Available

[Image]

                             CONNECTIONS

             Function                            Label

  RG-6A/U 75ohm coaxial connector                 CN1

                        USER CONFIGURABLE SETTINGS

                      Setting                        Label     Position

  IRQ2 enabled                                        E1        Closed

  IRQ2 disabled                                       E1         Open

                               NODE ADDRESS

  Setting   SW1/1   SW1/2   SW1/3   SW1/4   SW1/5   SW1/6   SW1/7   SW1/8

    1       Off      On      On      On      On      On      On      On

    2        On     Off      On      On      On      On      On      On

    3       Off     Off      On      On      On      On      On      On

    4        On      On     Off      On      On      On      On      On

    5       Off      On     Off      On      On      On      On      On

   251      Off     Off      On     Off     Off     Off     Off      Off

   252       On      On     Off     Off     Off     Off     Off      Off

   253      Off      On     Off     Off     Off     Off     Off      Off

   254       On     Off     Off     Off     Off     Off     Off      Off

   255      Off     Off     Off     Off     Off     Off     Off      Off

            Note: A total of 255 node address settings are available. The
            switches are a binary representation of the decimal node
            addresses. SW1/8 is the Most Significant Bit and switch SW1/1
            is the Least Significant Bit. The switches have the following
            decimal values: SW1/8=128, SW1/7=64, SW1/6=32, SW1/5=16,
            SW1/4=8, SW1/3=4, SW1/2=2, SW1/1=1. Turn off the switches and
            add the values of the switches that are off to obtain the
            correct node ID. (Off=1, On=0)

            Node address 0 is reserved and should not be used.

