
KATRON TECHNOLOGIES, INC.

KF-221TX, KF-221TX/2

Card Type              Network Interface Card
NIC Type               Ethernet
Maximum Onboard Memory Unidentified
Boot ROM               Unidentified
Network Transfer Rate  10Mbps, 100Mbps
Topology               Star bus
Wiring Type            Unshielded twisted pair
Data Bus               32-bit PCI

[Image]

                       CONNECTIONS

                    Function                      Label

  UTP connector                                    CN1

                          NETWORK SPEED SELECTION

  For 10BASE-T Ethernet networks, the Fast Ethernet adapter uses Category
  3, 4, or 5 UTP cable. To establish a valid 10 Mbps connection, the
  cable must be connected to a 10BASE-T hub.

  For 100BASE-TX Ethernet networks, the Fast Ethernet adapter uses
  Category 5 UTP cable. To establish a valid 100 Mbps connection, the
  cable must be connected to a 100BASE-TX hub.

                             DIAGNOSTIC LED(S)

    LED         Status                        Condition

   LED1           On         100BASE-TX connection is selected and active

   LED1          Off          100BASE-TX connection is not selected and
                                               active

   LED2           On         10BASE-TX connection is selected and active

   LED2          Off           10BASE-TX connection is not selected and
                                               active

   LED3        Blinking           Network traffic is present and is
                                       transmitting/receiving

   LED3          Off          Network traffic is not present and is not
                               transmitting/receiving for either speed

