
TECMAR

WANGTEK 5525ES (33711-XXX)

Device Type             Internal Tape Drive
Interface               SCSI-2 (Differential)
Format                  QIC-24 (read-only)

                        QIC-120, QIC-150, or QIC525 (write)
Sustained Transfer Rate 200 KBPS
Size                    5.25 in. half height
View                    Bottom


                      CONNECTIONS

          Function                     Label

  Chassis ground connector              W1

                        USER CONFIGURABLE SETTINGS

                  Setting                      Label         Position

     Factory configured - do not alter         E2             Open
      (Built in test mode(s))

     Factory configured - do not alter         E4             Open
      (Built in test mode(s))

     Factory configured - do not alter         E5            Closed
      (48 MHz main oscillator enabled)

     Factory configured - do not alter         JP2            Open
      (Built in test mode(s))

     Factory configured - do not alter         JP3       All pins open
      (Built in test mode(s))

     Factory configured - do not alter         JP6            Open
      (Built in test mode(s))

     Factory configured - do not alter        JP12            Open
      (Built in test mode(s))

     Factory configured - do not alter        JP32            Open
      (Diagnostic test connector)

                              DRIVE SELECT ID

     Drive ID            JP1/A              JP1/B             JP1/C

          0              Open              Open               Open

           1             Closed             Open               Open

           2              Open             Closed              Open

           3             Closed            Closed              Open

           4              Open              Open              Closed

           5             Closed             Open              Closed

           6              Open             Closed             Closed

           7             Closed            Closed             Closed

  Note: Jumper JP1/D is factory configured and should not be altered. The
  default position for JP1/D is Open.

                        TERMINATION POWER SELECTION

                  Setting                                 E1

     TERMPWR supplied by drive                         Closed

      TERMPWR supplied by SCSI interface                 Open
      to drive

  Note: The fuse must be installed at F1 when TERMPWR is supplied by the
  drive.

                       MISCELLANEOUS TECHNICAL NOTES

  Termination is enabled or disabled via the three removable terminating
  resistors (see diagram).

