
TECMAR

WANGTEK 5150ES (33678-XXX VER.1)

Device Type             Internal Tape Drive
Interface               SCSI
Format                  QIC-120, QIC-150 (write)

                        QIC-24, QIC-120, QIC-150 (read)
Sustained Transfer Rate 1800KBPS
Size                    5.25 in. half height
View                    Bottom


                        USER CONFIGURABLE SETTINGS

                 Setting                     Label          Position

     Factory configured - do not alter     JP3/A -       Unidentified
                                               C

      Parity check enabled                   JP3/D     Pins 1 & 2 closed

      Parity check disabled                  JP3/D      Pins 1 & 2 open

                            DRIVE SELECT ID

     Drive ID      JP1/Pins 1 & 2    JP1/Pins 3 & 4    JP1/Pins 5 & 6

        0               Open              Open              Open

        1              Closed             Open              Open

        2               Open             Closed             Open

        3              Closed            Closed             Open

        4               Open              Open             Closed

        5              Closed             Open             Closed

        6               Open             Closed            Closed

        7           Unidentified      Unidentified      Unidentified

                        TERMINATION POWER SELECTION

                  Setting                                 E1

     TERMPWR supplied by SCSI interface                Closed
      to drive

      TERMPWR supplied by drive                          Open

           MANUFACTURERS RECOMMENDED MEDIA

           Tape                     Capacity

          DC 600A            125 MB (in QIC-120 mode)

          DC 6150            150 MB (in QIC-150 mode)

          DC 6250            250 MB (in QIC-150 mode)


                             DIAGNOSTIC LED(S)

   LED      Color      Status                    Condition

  LED1      Amber      Flashing       Drive activity on the SCSI bus

  LED1      Amber      Pulsing         Drive fault condition exists

  LED1      Amber        Off                 Drive not active

  Note: "Pulsing" LED1 refers to a flash 1-5 times every 3 seconds.

                       MISCELLANEOUS TECHNICAL NOTES

  Termination is enabled or disabled via a terminating resistor (see
  diagram).

