
DIALOGIC CORPORATION

D/40D, D/40E, D/41D, D/41E

Card Type   Telephony
I/O Options AEB bus
Data Bus    8-bit ISA
Line Type   Loop-start

[Image]

                                CONNECTIONS

          Function            Label            Function             Label

  Lines 1 & 2                 CN1     Analog expansion bus           P3

  Lines 3 & 4                 CN2

                        USER CONFIGURABLE SETTINGS

                   Setting                      Label        Position

     IRQ termination enabled                    JP7           Open

      IRQ termination disabled                   JP7          Closed

     Board will use internal loop-start         JP8         Installed
      interface for input

      Board will use T1 interface via AEB        JP8       Not installed
      bus for input

     Disabled board will not answer            SW1/4           Off
      incoming calls

      Disabled board will send busy signal      SW1/4           On
      to incoming calls

            Note: If multiple D/4x cards are installed in a system, JP7
            should be closed for only one of them.

                             BASE I/O ADDRESS

          Setting                    JP5                     JP6

             A000h                  Closed                  Open

             C000h                   Open                  Closed

            D000h                   Open                   Open

                                 INTERRUPT

  Setting      JP1/A     JP1/B     JP1/C      JP1/D     JP1/E     JP1/F

     IRQ2    Closed      Open      Open      Open      Open       Open

      IRQ3     Open      Closed     Open      Open      Open       Open

      IRQ4     Open       Open     Closed     Open      Open       Open

      IRQ5     Open       Open      Open     Closed     Open       Open

      IRQ6     Open       Open      Open      Open     Closed      Open

      IRQ7     Open       Open      Open      Open      Open      Closed

            Note: All D/4xx boards in the system should be set to the
            same interrupt.

                  BASE I/O ADDRESS OFFSET (BOARD NUMBER)

     Setting       Board Number      SW1/1         SW1/2         SW1/3

        000h           1             Off           Off           Off

         200h           2             Off           Off           On

         400h           3             Off           On            Off

         600h           4             Off           On            On

         800h           5             On            Off           Off

         A00h           6             On            Off           On

         C00h           7             On            On            Off

         E00h           8             On            On            On

