
BANKSIA TECHNOLOGY PTY., LTD.

MY MODEM

Card Type                    Fax, Modem (asynchronous)
Chip Set                     Unidentified
Maximum Data Rate            14.4Kbps
Maximum Fax Rate             14.4Kbps
Data Bus                     External
Fax Class                    Class I & II
Data Modulation Protocol     Bell 103/212A

                             ITU-T V.21, V.22, V.22bis, V.32, V.32bis
Fax Modulation Protocol      ITU-T V.17, V.27ter, V.29
Error Correction/Compression MNP5, MNP10, V.42, V.42bis

[Image]

                                CONNECTIONS

         Function           Label             Function             Label

  Line out                       CN1       DC power                 CN4

  Line in                        CN2       Power switch             SW1

  RS-232/422                     CN3

                             DIAGNOSTIC LED(S)

   LED      Color    Status                    Condition

   PWR       Red       On                     Power is on

   PWR       Red      Off                    Power is off

    OH       Red       On                  Modem is off-hook

    OH       Red      Off                  Modem is on-hook

   DTR       Red       On                 DTR signal is high

   DTR       Red      Off                  DTR signal is low

   DCD       Red       On               Carrier signal detected

   DCD       Red      Off             Carrier signal not detected

   CTS       Red       On             Modem ready to receive data

   CTS       Red      Off           Modem not ready to receive data

   RTS       Red       On           Computer ready to receive data

   RTS       Red      Off         Computer not ready to receive data

   RXD       Red       On               Modem is receiving data

   RXD       Red      Off             Modem is not receiving data

   TXD       Red       On             Modem is transmitting data

   TXD       Red      Off           Modem is not transmitting data

    AA       Red       On                 Auto-answer enabled

    AA       Red      Off                Auto-answer disabled

   TST       Red       On                 Modem in test mode

   TST       Red      Off               Modem not in test mode

                           SUPPORTED COMMAND SET

                             Basic AT Commands

  AT, +++, Comma, A/

  A, B, E, H, I, L, M, N, O, P, Q, S, T, V, W, X, Y, Z

  &C, &D, &F, &K, &L, &P, &S, &T, &V, &W, &Y, &Z

                           Extended AT Commands

  \A, \B, \G, \L, %C, %L, %Q

                                S Registers

  S0, S1, S2, S3, S4, S5, S6, S7, S8, S9, S10, S11, S12, S14, S16, S18,
  S21, S22, S24, S25, S26

  S29, S30, S31, S32, S33, S36, S37, S38, S39, S46, S48, S82, S86, S91,
  S92, S95

                             Special Commands

  *H, -K, -Q, )M, @M, :E, +MS

  Note: See MHI Help file for full command documentation.

                         Proprietary AT Command Set

                           MODULATION SELECTION

  Type:           Configuration

  Format:         AT [cmds] Fn [cmds]

  Description:    Controls line modulation unless automode is selected

     Command                             Function

       F0         Automode enabled

       F1         Force V.21 or Bell103 (according to ATB command) at
                  300bps

       F2         OK returned

       F3         Force V.23 75TX/1200RX originate or 1200TX/75RX answer
                  FSK

       F4         Force V.22 or Bell212A (according to ATB command) at
                  1200bps

       F5         Force V.22bis or Bell2400 (according to ATB command)

       F6         Force V.32 at 4800bps

       F7         Force V.32 at 7200bps

       F8         Force V.32 at 9600bps

       F9         Force V.32bis at 12000bps

       F10        Force V.32bis at 14400bps

  For remaining proprietary command summary, See BANKSIA TECHNOLOGY PTY.,
                            LTD., MAC MODEM 288.

