
DIALOGIC CORPORATION

D/21D (REV. 3)

Card Type    Telephony
I/O Options  AEB bus, Line in via RJ-14 (2)
Data Bus     8-bit ISA
Line Type    Loop-start

[Image]

                                CONNECTIONS

          Function            Label            Function             Label

  Line in                      J1     Analog expansion bus           P3

  Line in                      J2

                        USER CONFIGURABLE SETTINGS

                   Setting                        Label       Position

     IRQ termination enabled                      JP7          Open

      IRQ termination disabled                     JP7         Closed

     Board will use internal loop-start           JP8         Closed
      interface for input

      Board will use T1 interface via AEB          JP8          Open
      bus for input

     Disabled board will not answer              SW1/4          Off
      incoming calls

      Disabled board will send busy signal        SW1/4          On
      to incoming calls

            Note:If multiple D/4x cards are installed in a system, JP7
            should be closed for only one of them.

                        CHANNEL 1 RING DETECTION

              Setting                              JP101

  Ring detection threshold normal                  Open

  Ring detection threshold lowered                Closed

  Note: A lowered threshold may cause false detection of rings

                        CHANNEL 2 RING DETECTION

              Setting                              JP201

  Ring detection threshold normal                  Open

  Ring detection threshold lowered                Closed

  Note: A lowered threshold may cause false detection of rings

                             BASE I/O ADDRESS

     Setting          JP5        JP6       SW1/1       SW1/2      SW1/3

        A0000h      Closed       Open       Off         Off        Off

        A2000h      Closed       Open       Off         Off         On

        A4000h      Closed       Open       Off         On         Off

        A6000h      Closed       Open       Off         On          On

        A8000h      Closed       Open        On         Off        Off

       D0000h       Open        Open       Off         Off        Off

        D6000h       Open        Open       Off         On          On

        D8000h       Open        Open        On         Off        Off

        DA000h       Open        Open        On         Off         On

        DC000h       Open        Open        On         On         Off

        DE000h       Open        Open        On         On          On

                                   Note:

  A total of 32 base address settings are available. The switches are a
  binary representation of the decimal memory addresses. JP5 is the Most
  Significant Bit and switch SW1/3 is the Least Significant Bit. The
  switches have the following decimal values: JP5=131072 JP6=65536,
  SW1/1=32768, SW1/2=16384, SW1/3=8192. Turn off the switches and add the
  values of the switches to obtain the correct memory address. (Off=1,
  On=0)

                                 INTERRUPT

  Setting      JP1/A     JP1/B     JP1/C      JP1/D     JP1/E     JP1/F

             Closed      Open      Open      Open      Open       Open

      IRQ3     Open      Closed     Open      Open      Open       Open

      IRQ4     Open       Open     Closed     Open      Open       Open

      IRQ5     Open       Open      Open     Closed     Open       Open

      IRQ6     Open       Open      Open      Open     Closed      Open

      IRQ7     Open       Open      Open      Open      Open      Closed

            Note: All D/21D & D/41D boards in the system should be set to
            the same interrupt.

