
ACTIONTEC ELECTRONICS, INC.

DATALINK 56K

Card Type                    Modem, Fax
Chip Set                     Unidentified
Maximum Modem Rate           56Kbps
Maximum Fax Rate             14.4Kbps
Data Modulation Protocol     Unidentified
Fax Modulation Protocol      Unidentified
Error Correction/Compression MNP5, V.42bis
Fax Class                    Unidentifed
Data Bus                     PCMCIA

                                                                      54676

                   SUPPORTED COMMAND SET

                     Basic AT Commands

  AT, A/

  A, E, H, V, Z

  &F, &W



  Note: See MHI Help File for full command documentation.

                         PROPRIETARY AT COMMAND SET

                                   DIAL

  Type:                  Immediate

  Format:                AT [cmds] D<#> [cmds]

  Description:           Dials telephone number according to any
                         modifiers included in the string

  Note:                  Any combination of modifiers can be used to
                         produce the desired dial functions in sequence.

        Command                              Function

          DP             Pulse dialing enabled

          DT             Tone dialing enabled/Pulse dialing disabled

          D,             Dialing paused for amount of time specified in
                         S8 register

                              SPEAKER VOLUME

  Type:          Configuration

  Format:        AT [cmds] Ln [cmds]

  Description:   Controls speaker volume

    Command                              Function

       L0        Speaker disabled

       L2        Volume on

                               SPEAKER MODE

  Type:          Configuration

  Format:        AT [cmds] Mn [cmds]

  Description:   Selects various speaker options

    Command                              Function

       M0        Speaker disabled

       M1        Speaker enabled until carrier signal detected

       M2        Speaker enabled

                           EXTENDED RESULT CODES

  Type:                 Configuration

  Format:               AT [cmds] Wn [cmds]

  Description:          Reports modem progress

       Command                              Function

          W0            Enables CONNECT result codes to report modem type
                        and DTE speed.

          W1            Enables CONNECT result codes to report DTE speed,
                        carrier, protocol, and compression

          W2            Enables CONNECT result codes to report DCE
                        speed..

                         DATA CARRIER DETECT (DCD)

  Type:          Configuration

  Format:        AT [cmds] &Cn [cmds]

  Description:   Selects whether the DCD option is enabled or disabled

    Command                              Function

      &C1        DCD enabled after carrier signal detected

                         DATA TERMINAL READY (DTR)

  Type:          Configuration

  Format:        AT [cmds] &Dn [cmds]

  Description:   Selects modem response to DTR

    Command                              Function

      &D2        DTR enabled

