
ARCHTEK CORPORATION

56PCI-R

Card Type                    Modem/Fax card
Chip Set                     Unidentified
Maximum Modem Rate           56Kbps
Maximum Fax Rate             14.4Kbps
Data Modulation Protocol     Bell 103A/212A

                             ITU-T V.21, V.22, V.22bis, V.23, V.32, V.34,
                             V.34bis, K56flex
Fax Modulation Protocol      ITU-T V.17, V.27ter, V.29, V.21CH2
Error Correction/Compression MNP5, V.42, V.42bis
Fax Class                    Class I
Data Bus                     PCI

[Image]

                                CONNECTIONS

        Function           Label             Function              Label

  Line out (RJ-11)              CN1      Microphone jack            CN3

  Line in (RJ-11)               CN2      Speaker jack               CN4

                   SUPPORTED COMMAND SET

                     Basic AT Commands

  AT, +++, A/

  A, E, H, M, O, P, V, Z

  &C,&W

                     Special Commands

  +MS

                        S Registers

  S0, S1, S2, S3, S4, S5, S6, S7, S8, S9, S10, S11, S12



  Note: See MHI Help File for full command documentation.

                         PROPRIETARY AT COMMAND SET

                         DATA TERMINAL READY (DTR)

  Type:          Configuration

  Format:        AT [cmds] &Dn [cmds]

  Description:   Selects modem response to DTR

    Command                              Function

      &D0        DTR override

      &D1        DTR toggle causes online command mode

      &D2        Normal DTR operations

      &D3        Resets on receipt of DTR

                                   DIAL

  Type:                  Immediate

  Format:                AT [cmds] D<#> [cmds]

  Description:           Dials telephone number according to any
                         modifiers included in the string

  Note:                  Any combination of modifiers can be used to
                         produce the desired dial functions in sequence.

        Command                              Function

          DP             Pulse dialing enabled

          DT             Tone dialing enabled/Pulse dialing disabled

          DW             Dialing resumed following dial tone detection

          D^             Data calling tone disabled

                          FACTORY DEFAULT PROFILE

  Type:             Configuration

  Format:           AT [cmds] &F [cmds]

  Description:      Sets values in active profile to values found in the
                    default profile

     Command                              Function

       &F0          Restore stored profile 0 after warm reset

       &F1          Restore stored profile 1 after warm reset

                            REPORT INFORMATION

  Type:          Immediate

  Format:        AT [cmds] In [cmds]

  Description:   Displays information requested

    Command                              Function

       I0        Reports product code

       I1        Reports OK

       I2        Tests and reports ROM checksum

       I3        Reports modem firmware revision information

       I4        Reports OEM identifier string

       I6        Reports modem data pump model and internal code revision



