
PIXELWORKS, INC.

WHIRLWIN/LITE

Category                    Video
Video Types Supported       XVGA
Video Processor             S3 86C924
Highest Resolution          1024 x 768
Supported
Data Bus Type               16-bit ISA
Memory Type                 VRAM
Maximum Onboard Memory      1024KB

[Image]

                                CONNECTIONS

       Purpose          Location            Purpose            Location

  15-pin video             CN1        VGA feature connector       CN2
  analog port

                        MONITOR TYPE CONFIGURATION

          Type                 Rate            SW1/1           SW1/2

      Multisync 48KHz         60Hz              On             Off

       Multisync 38KHz        43.5Hz            Off              On

       Multisync 57KHz         72Hz              On              On

        VGA, Super VGA        43.5Hz            Off             Off

                         TURBO MODE CONFIGURATION

                 Setting                               SW1/3

                  Disabled                             Off

                   Enabled                               On

                            BIOS TYPE SELECTION

                  Type                                 SW1/4

                   8-bit                               On

                   16-bit                               Off

                         ZERO WAIT STATE SELECTION

                Setting                                 JP3

                 Disabled                       Pins 2 & 3 closed

                   Enabled                       Pins 1 & 2 closed

                       VIDEO INTERRUPT CONFIGURATION

                IRQ 2/9                                 JP4

                 Disabled                       Pins 2 & 3 closed

                   Enabled                       Pins 1 & 2 closed

                         MONITOR ID CONFIGURATION

                 Mode                                  JP5

                  Sense                        Pins 2 & 3 closed

                    MID1                        Pins 1 & 2 closed

       Note: In the "Sense" mode the WhirlWin/Lite will automatically
       detect the monitor being used. In the "MID1 mode, the ID
       information from the monitor will be read by software which
       supports this feature.

    FACTORY CONFIGURED - DO NOT ALTER

       Jumper              Position

         JP1          Pins 2 & 3 closed

         JP2          Pins 1 & 2 closed

