##1##
* Network Adapters List *

The list is the net cards found on your system. Select the net card which
you want to configure by using the arrow key.


Key definition:

F1      Help screen about this menu.

Enter   Select the card and enter the main menu.

Esc     return to DOS.
##2##

##3##
* Configuration Menu *

The configuration menu consists of five functions:

1.  I/O Base Address

    A Range from 0x200 - 0x3E0 is supported for this setting.

    I/O Addresses that are in  use  by  other  devices  will  be
    dimmed so that you cannot select them.

    Note  that  if  your system is in Plug an Play mode, then IO
    base address is assigned by system and can not be modified.


2.  Interrupt Output Line

    IRQ's that are in use by other devices  will  be  dimmed  so
    that you cannot select them.

    Note  that  if your system is in Plug an Play mode, then the
    IRQ is assigned by system and can not be modified.


3.  Boot ROM Base Address

    You can select Boot  ROM  size  for  16K,  32K,  64K  or  NO
    BOOTROM.

    Then  you  can  select  Boot ROM base address. The addresses
    already been used will show in gray color,  you  can  choose
    only from the addresses which show in green color.

    Note  that  if your system is in Plug an Play mode, then the
    Boot ROM base address is assigned by system and can  not  be
    modified.


5.  PNP or Jumperless mode

    If your system supports plug and play, for example your BIOS
    is  a  PNP  BIOS or your OS is WINDOWS 95. You should select
    PNP mode.

    Select Jumperless to use the BENCFG utility to configure the
    card.

Key definition:

F1      Help screen about this menu.

F10     Save the configuration permanently. It will require you to do the
        power off hardware reset unless you ignore those settings and set
        them again.

Enter   Enter the selected sub-menu.

Esc     return to previous menu.
##4##
* Install Drivers and Utilities Menu *


##5##
* Install Plug & Play Utility Menu *

##6##
* Install DOS ODI Driver Menu *

##7##
* Install DOS PACKET Driver Menu *

##8##
