         FLAGS

        These can either be entered on the command line, when the
        program is first run, or when the "Configure settings" option is
        chosen <CONFIGUR>, or in batch mode instead of an ID <BATCH>.
        All flags may be upper or lower case. To use flags on the
        command line enter: 

        PEDRAW /FLAG1 /FLAG2 etc.

        or:

        PEDRAW datafile.dat /FLAG1 /FLAG2 etc.

        The section on the "Configure settings" option clarifies the 
        effects of some of the flags <CONFIGUR>. 

        /P <PFLAG>
        /E <EFLAG>
        /G <GFLAG>
        /L <LFLAG>
        /T <TFLAG>
        /F <FFLAG>
        /A <AFLAG>
        /B <BFLAG>
        /U <UFLAG>
        /M <MFLAG>
        /R <RFLAG>
        /C <CFLAG>
        /GW <GWFLAG>
        /SW <SWFLAG>
        /GH <GHFLAG>
        /SH <SHFLAG>
        /H <HFLAG>
        
