(tar)Archive Structure

Modifiers Options

Special Options for Archiving

Format Control

The Structure of an Archive
===========================

     *(This message will disappear, once this node revised.)*

   While an archive may contain many files, the archive itself is a
single ordinary file.  Like any other file, an archive file can be
written to a storage device such as a tape or disk, sent through a pipe
or over a network, saved on the active file system, or even stored in
another archive.  An archive file is not easy to read or manipulate
without using the `tar' utility or Tar mode in Emacs.

   Physically, an archive consists of a series of file entries
terminated by an end-of-archive entry, which consists of 512 zero
bytes.  A file entry usually describes one of the files in the archive
(an "archive member"), and consists of a file header and the contents
of the file.  File headers contain file names and statistics, checksum
information which `tar' uses to detect file corruption, and information
about file types.

   More than archive member can have the same file name.  One way this
situation can occur is if more than one version of a file has been
stored in the archive.  For information about adding new versions of a
file to an archive,
FIXME: pxref Modifying
   .

   In addition to entries describing archive members, an archive may
contain entries which `tar' itself uses to store information.

FIXME: xref Archive Label
   , for an example of such an archive entry.