SORT

Reads input, sorts data, and writes the results to the screen, a file,
or another device.

SORT acts as a filter, reading characters in a specified column and
rearranging them in ascending or descending order.

Syntax

    SORT [/R] [/+n] [<] [drive1:][path1]filename1
    [> [drive2:][path2]filename2]

    [command |] SORT [/R] [/+n] [> [drive2:][path2]filename2]

Parameters

[drive1:][path1]filename1
    Specifies the location and name of the file whose data you want to
    sort.

[drive2:][path2]filename2
    Specifies the location and name of a file in which the sorted output
    is to be stored.

command
    Specifies a command whose output is the data you want to sort.

Switches

/R
    Reverses the order of the sorting operation; that is, sorts from Z
    to A, and then from 9 to 0.

/+n
    Sorts the file according to the character in column n. If you do not
    use this switch, the SORT command sorts data according to the
    characters in column 1.

Related Command

For information about displaying information one screen at a time, see
the <MORE> command.

SORT Notes

Specifying a source

Unless you specify the command or filename parameter, SORT acts as a
filter and takes input from the MS-DOS standard input (usually from the
keyboard, from a pipe, or from a file).

Using redirection symbols with SORT

You can use the pipe (|) or the less-than sign (<) to direct data
through the SORT command from command or filename. If you want to
display the information one screen at a time or direct the information
to a file, you can also specify the MORE command or a filename. You can
use the greater-than sign (>) to direct the sorted output to a file.

Before using a pipe for redirection, you should set the TEMP environment
variable in your AUTOEXEC.BAT file.

Collating sequence

The SORT program uses the collating-sequence table corresponding to the
country code and code-page settings. Characters greater than ASCII code
127 are sorted based on information in the COUNTRY.SYS file or in an
alternate file specified by the COUNTRY command in your CONFIG.SYS file.

Uppercase vs. lowercase

SORT does not distinguish between uppercase and lowercase letters.

Limits on file size

The SORT command can handle files as large as 64K.

SORT Examples

The following command reads the file EXPENSES.TXT, sorts it in reverse
order, and displays it on your screen:

    sort /r < expenses.txt

Suppose you want to search a large file named MAILLST.TXT for the text
"Jones", and suppose you want to sort the results of the search. To do
this, use the pipe (|) to direct the output of a FIND command to the
SORT command, as shown in the following example:

    find "jones" maillst.txt | sort

The command produces a sorted list of lines that contain the specified
text.

To sort keyboard input and display the results alphabetically on the
screen, you can first use the SORT command with no parameters, as the
following example shows:

    SORT

Then type the text you want sorted, pressing ENTER at the end of each
line. When you have finished typing text, press CTRL+Z, and then press
ENTER. The SORT command displays the text you typed, sorted
alphabetically. You could also redirect sorted keyboard input to a file.

End of Document
